Micrel
Functional Diagram
Figure 1. Simplified Block Diagram.
MICRF211
? Operating Freq (MHz) ?
Functional Description
Figure 1. Simplified Block Diagram that illustrates the
basic structure of the MICRF211. It is made of three
sub-blocks; Image Rejection UHF Down-converter, the
OOK Demodulator, and Reference and Control Logics.
Outside the device, the MICRF211 requires only three
components to operate: two capacitors (CTH, and
CAGC) and the reference frequency device, usually a
quartz crystal. An additional five components may be
used to improve performance. These are: power supply
decoupling capacitor, two components for the matching
network, and two components for the pre-selector band
pass filter.
Receiver Operation
LNA
The RF input signal is AC-coupled into the gate circuit of
the grounded source LNA input stage. The LNA is a
Cascoded NMOS.
Mixers and Synthesizer
The LO ports of the Mixers are driven by quadrature
is set to 32 times the crystal reference frequency via a
phase-locked loop synthesizer with a fully integrated
loop filter.
Image Reject Filter and Band-Pass Filter
The IF ports of the mixer produce quadrature down
converted IF signals. These IF signals are low-pass
filtered to remove higher frequency products prior to the
image reject filter where they are combined to reject the
image frequencies. The IF signal then passes through a
third order band pass filter. The IF center frequency is
1.2MHz. The IF BW is 330kHz @ 433.92MHz, and this
varies with RF operating frequency. The IF BW can be
calculated via direct scaling:
BW IF = BW IF@433.92 MHz × ? ?
? 433.92 ?
These filters are fully integrated inside the MICRF211.
After filtering, four active gain controlled amplifier stages
enhance the IF signal to proper level for demodulation.
OOK Demodulator
The demodulator section is comprised of detector,
local oscillator outputs from the synthesizer block. The
programmable
low pass
filter, slicer,
and
AGC
local oscillator signal from the synthesizer is placed on
the low side of the desired RF signal to allow
suppression of the image frequency at twice the IF
frequency below the wanted signal. The local oscillator
comparator.
Detector and Programmable Low-Pass Filter
The demodulation starts with the detector removing the
March 2007
6
M9999-030107
(408) 944-0800
相关PDF资料
MICRF213AYQS TR IC RX 3.3V 300-350 MHZ 16QSOP
MICRF218AYQS TR IC RCVR QWIKRADIO 3.3V 16QSOP
MICRF219AAYQS TR IC RECEIVER QWIKRADIO 16QSOP
MICRF219AYQS TR IC RECEIVER QWIKRADIO 16QSOP
MICRF220AYQS TR RCVR ASK/OOK 300-450MHZ 16QSOP
MICRF221AYQS TR IC RF RECEIVER QWIKRADIO 16-QSOP
MICRF300YC6 TR IC AMP 100/1000MHZ LN SC70-6
MICRF500BLQTR TXRX UHF 700-1100MHZ 44-LQFP
相关代理商/技术参数
MICRF213 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3.3V, QwikRadio㈢ 315MHz Receiver
MICRF213_11 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3.3V, QwikRadio 315MHz Receiver
MICRF213AYQS 功能描述:射频接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
MICRF213AYQS TR 功能描述:射频接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
MICRF218 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver
MICRF218_11 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver
MICRF218AYQS 功能描述:射频接收器 300MHz to 450MHz, 3.0V to 3.6V, <10kbps, 4mA, Wide-IF Bandwidth ASK Receiver with RSSI, Shutdown in 16-Lead QSOP RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
MICRF218AYQS TR 功能描述:射频接收器 300MHz to 450MHz, 3.0V to 3.6V, <10kbps, 4mA, Wide-IF Bandwidth ASK Receiver with RSSI, Shutdown in 16-Lead QSOP RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel